Effect of friction stir processing on grain refinement and superplastic properties of binary Al-8 wt.% Si to Al-30 wt.% Si alloys

As-cast binary Al–Si alloys containing ∼8, 12, 20, and 30 wt.% Si, representing the hypoeutectic, eutectic (12 wt.% Si), and hypereutectic compositions, were subjected to severe plastic deformation by friction stir processing (FSP) for grain refinement to 2.3–2.7 μm by dynamic recrystallization. Tensile tests conducted by differential strain rate test technique over the strain rates of 10−4–10−2 s−1 and test temperatures in the range of ∼840–530 K led to strain rate sensitivity index (m) varying from ∼0.04 to 0.40 depending on temperature, strain rate, and alloy composition. The constant initial strain rate tests conducted at 10−4 s−1 and 840 K exhibited a maximum elongation of 250% in the hypereutectic Al–20Si alloy, but the same increased linearly with m irrespective of alloy composition. Generally, with increasing Si content, the activation energy for deformation increased from 104.7 ± 14.4 kJ/mol for eutectic Al–12Si to 310.4 ± 32.3 kJ/mol for hypereutectic Al–30Si, which increased further to 572 ± 148 kJ/mol over the higher temperature range of 840–800 K. Analysis of observed deformation and microstructure behaviour supports the occurrence of superplasticity, whereby the accommodation of grain boundary sliding by grain boundary migration led to enhanced grain growth or else the local high-stress concentration at the particle-matrix interface led to cavity formation. There was no evidence of dynamic recrystallization during high-temperature tensile deformation but the flow softening observed is ascribed to the occurrence of concurrent cavitation.